Technical Specification

Evaporator Coils

Dilution: 1:8 parts water. Start cleaning at top of could and work methodically across and down.

Split style units

Turn off unit and isolate electrics. Apply diluted EnviroCoil 2.0 with a low pressure sprayer set on a coarse spray pater, Soak the coil. Allow product to work for five minutes. No rinsing required – cooling process should naturally rinse coil. However, heat pump systems should be rinsed. Turn unit on.

Large air handling units

If possible, leave air flow on – allowing suction to ensure complete coil penetration. If not possible, turn air flow on immediately after application. Apply diluted Envirocoil 2.0 with a low pressure sprayer set on a coarse spray pattern. Saturate coil to run-off point. Rinse thoroughly with clean water.

Air-cooled condensers

Dilution – 1:4 parts water. Apply diluted EnviroCoil 2.0 with a low pressure sprayer set on a coarse spray pattern. Allow product to work for 5-10 minutes. Rinse away dirt and contamination with clean water. Rinse water is not hazardous and will not harm any surrounding materials or equipment. Start cleaning at top of coil and work methodically down and across. Cleaning is more effective if condenser is still warm.

Air Filters

EnviroCoil 2.0 can also be used to clean electronic air filters. Turn unit and fans off. Dilute with 1:2 parts water, spray liberally and allow to penetrate for 5 minutes. Rinse thoroughly with clean water.